
HH80CE 4″x3″ Electric Pump
Equipment Sold is Not to be Rented
- Discharge Flange3"
- Dry WeightN/A
- Footprint100” x 54”
- Fuel CapacityN/A
- Impeller DiameterN/A
- Max Flow480 GPM
- Max Head240 ft
- Priming MethodSelf-Priming
- Pump Size4"x3"
- Solids0.41"
The 4” suction x 3” discharge self-priming centrifugal HH80CE electric high head pump provides up to a maximum of 480 gallons per minute pumping and up to 240 feet of head. This pump is usually mounted on a skid and features the standard PowerPrime Clean Prime Venturi priming system which allows it to run continuously, unattended and even run dry.
Features
Accessories
Specs
- Continuous self-priming
- Runs dry unattended
- Compressor fitted to operate the air-ejector priming system
- 7 vane, 14” brass impeller
- Suction lift up to 28ft.
- Hot Dip Galvanized Open Skids with fork lift tubes
- Four corner bolt down angles
- Stainless steel and CD4MCu pump end options
- TEFC hostile duty dual voltage (230/460V) motor
- Fitted 480 volt control panels are equipped with motor protection
- Panels are equipped with terminal blocks for remote float switches
- E-CONTAIN® Spillguard
- SolidGround® Traction Mats
- Variable Frequency Drive (VFD)
- PipeStax®
- Maximum Flow 480 GPM
- Maximum Head 240 feet
- Pump Size 4” x 3”
- Maximum Solids Handling 0.41 inch
- Operating Speed 1775 rpm
- Footprint 100” x 54”